Adjust the arc and distance to suit your needs. Powerful three-way repellent, uses water + noise + motion Minimal water usage short bursts when movement detected Three operating modes: 24 hours, day only or night only Connect motion activated water sprinklers together to cover more area from one tap Super versatile, with an adjustable height up to 75cm. Raise or lower the water deflector dial to control the distance of the water spray. Stem tabs determine the arc range of the ScareCrow from 0 to 300 degrees. Position the stem tabs so the metal wire clip travels between these tabs and faces the area to be sprayed. Make sure the water is turned OFF, then follow the steps below. Repeat this process until you have a good idea of the ScareCrow's area of coverage at this setting.Īfter you have set the ScareCrow's sensitivity and positioned it securely with its lens aimed at the desired area, use this section to help you adjust the arc and distance of the ScareCrow's water spray. After the 3 second pulse of water, remain still for approximately 8 seconds after each activation, while the ScareCrow resets itself. Make minor adjustments until you feel the ScareCrow will only trigger when movement is detected inside the you wish to protect. The ScareCrow's sprinkler will activate once it detects you. Start outside your desired coverage area and work your way inwards. It is not beneficial to sense animals or moving objects outside the area you wish to protect. Set the sensitivity knob high enough to see to target animal when it is within reach of the 10 meter (35 foot) water spray, but not beyond that point. If the ground is too hard or otherwise unsuitable for the plastic stake, try placing the ScareCrow in a flower pot filled with a weighted material like sand or grave. Do not push on the sensor housing or sprinkler head. Push the spike into the ground by stepping on the footrest. Connect hose and position the ScareCrow.Īim the ScareCrow towards the area you want to protect. There is an 8 second reset interval after the valve closes when the sensor does not detect motion.Īssemble stake and attach sprinkler head and stake to housing. This motion-activated sprinkler detects and sprays animals in a 1000-square-foot area day and night. You should easily hear the ScareCrow's internal water valve click open, then click closed 3 seconds later. Next, wave your hand in front of the sensor lens. Here are the instructions for setting up the ScareCrow sprinkler:įirst, turn the sensitivity knob to 4 or 5.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |